Fair faced, one component polymer modified cementitious filler and reprofiling mortar

Uses:

Renderoc BF is designed for application to imperfections in concrete and masonry surfaces. It is suitable for application upto 5mm thickness, and can be used in the following situations:
- Filling blow holes prior to overcoating
- Skim-coat over concrete to receive protective coatings
- General reprofiling over large areas
- Reprofiling, in association with other Renderoc mortars

Advantages:

- Cost effective/ time saving - no independent primer or curing agents required
- High performance - excellent bond to substrate
- User friendly - requires addition of water only
- Suitable to receive protective coatings

Description:

Renderoc BF is supplied as a ready to use blend of dry powders and polymers, which requires only the addition of water to produce a highly consistent cementitious mortar, with good handling characteristics.
Renderoc BF exhibits excellent thermal compatibility with concrete and is fully compatible with other Renderoc* mortars and Dekguard* protective coatings.

Design Criteria:

Renderoc BF is designed for vertical and overhead use to infill surface imperfections of concrete upto 5mm thick.

Limitations:

- Renderoc BF should not be used when the temperature is below 5°C and falling.
- Do not proceed with the application when rainfall is imminent unless in a sheltered or protected situation.
- If any doubts arise concerning temperature or substrate conditions, consult the local Fosroc office.

* Denotes the trademark of Fosroc International Limited
† See separate data sheet

Technical Datasheet

Method Statement

Safety Datasheet